Often asked: How To Change The Thermostat In A 2012 Dodge Journey?

Thermostat :

The thermostat for 2.0L diesel and 2.4L gas engines is located in the thermostat housing/coolant inlet and is controlled by a wax pellet driven, reverse poppet choke type thermostat. Disconnect negative cable from remote jumper terminal. Disconnect coolant hoses (1) from rear of coolant adapter (2) and remove radiator hose tube mounting bolt (3)
Warning: Do not loosen the radiator cap while the cooling system is hot and pressurized, as this could result in serious coolant burns. 2.4L – PRIMARY THERMOSTAT – COOLANT HOSE – INLET HOUSING – BOLT. Lubricate O-rings with soapy water. Position coolant adapter on water pump inlet tube and cylinder head. Tighten attaching bolts to 18.1 N.m (159 in. lbs.). Connect

Does a 2012 Dodge Journey have two thermostats?

The primary thermostat for the 2.0L diesel and 2.4L gas engines is located in the thermostat housing/coolant inlet on the front of the water plenum, while the secondary thermostat is located in the cylinder head under the water plenum.

Why is my 2012 Dodge Journey overheating?

A coolant leak (water pump, radiator, hose, etc. ), the radiator fan, or a failed thermostat are the most common three reasons for your Dodge Journey overheating.

Does a 2013 Dodge Journey have 2 thermostats?

The cooling system of a vehicle with this engine size has a primary and secondary thermostat, which open at different temperatures. The secondary thermostat opens at 203 degrees Fahrenheit and should be fully open at 230 degrees Fahrenheit.

Can you change a car thermostat yourself?

Replacing a car’s thermostat (also known as a T-stat) is a simple and inexpensive repair that will usually solve an overheating or no-heat problem, saving you time and money on expert diagnostics.

We recommend reading:  Question: How To Check Season Journey On Diablo?

Where is the secondary thermostat located?

The primary thermostat is located on the front of the water plenum in the thermostat housing, and the secondary thermostat is located in the cylinder head under the water plenum; one or both thermostats could be bad.

Why does a Dodge Avenger have two thermostats?

The inlet cooling to the engine is controlled by a double-valve thermostat that mixes a re-circulating sensing flow with the radiator cooling flow in this setup.

How do you start a car after it overheats?

When Your Engine Overheats, What Should You Do?

  1. Turn off the air conditioner and crank up the heat to relieve stress on the engine.
  2. Find a safe place to pull over. Pull over and shut off the car.
  3. Check and add coolant (if necessary).
  4. Restart the engine.

What temperature should a Dodge Journey run at?

The normal operating engine temperature for most cars is between 195 and 220 degrees Fahrenheit, though most dashboard temperature gauges don’t display an exact temperature, instead showing cold and hot markings on the gauge’s edges and a normal range in the middle.

Where is the thermostat on a 2009 Dodge Journey?

The thermostat in the 2009 Dodge Journey 3.5 is located inside the coolant line that connects the water pump to the radiator, and its purpose is to allow the car to reach the optimum operating temperature in the shortest time possible.

How much does a thermostat cost for a 2013 Dodge Journey?

Thermostats for the 2013 Dodge Journey start at $13.99 on AutoZone.com.

Why do some cars have 2 thermostats?

The dual thermostat system was designed to achieve the same temperature control under different load conditions by varying the coolant flow to the radiator rather than manipulating the air side of the radiator.

We recommend reading:  Quick Answer: How Many Prisoners Survived The Journey In Night?

Where is thermostat in 2015 Dodge Journey?

The thermostat is located near the front of the engine, on the lower left side.

How hard is it to change your thermostat?

According to the EPA, upgrading to a thermostat that automatically changes the indoor temperature setting is relatively simple and can save you about $180 per year in heating and cooling costs. Simple models that only control heat are sold for around $25 at home centers.

Can you change a thermostat without draining the coolant?

No, the thermostat cannot be changed without draining the radiator; however, draining the radiator is simple with the stopcock on the bottom right of the radiator; once drained, the entire process will go quickly because the thermostat is VERY easy to access.

Leave a Reply

Your email address will not be published. Required fields are marked *