Quick Answer: How To Change A Thermostat On A 2013 Dodge Journey?

Thermostat :

The thermostat for 2.0L diesel and 2.4L gas engines is located in the thermostat housing/coolant inlet and is controlled by a wax pellet driven, reverse poppet choke type thermostat. Disconnect negative cable from remote jumper terminal. Disconnect coolant hoses (1) from rear of coolant adapter (2) and remove radiator hose tube mounting bolt (3)
Warning: Do not loosen the radiator cap while the cooling system is hot and pressurized, as this could result in serious coolant burns. 2.4L – PRIMARY THERMOSTAT – COOLANT HOSE – INLET HOUSING – BOLT. Lubricate O-rings with soapy water. Position coolant adapter on water pump inlet tube and cylinder head. Tighten attaching bolts to 18.1 N.m (159 in. lbs.). Connect

Does a 2013 Dodge Journey have 2 thermostats?

The cooling system of a vehicle with this engine size has a primary and secondary thermostat, which open at different temperatures. The secondary thermostat opens at 203 degrees Fahrenheit and should be fully open at 230 degrees Fahrenheit.

What causes a 2013 Dodge Journey to overheat?

A coolant leak (water pump, radiator, hose, etc. ), the radiator fan, or a failed thermostat are the most common three reasons for your Dodge Journey overheating.

Where is the thermostat located in a 2015 Dodge Journey?

At the water inlet, there is a Duralast Thermostat 65870.

How much does a thermostat cost for a 2013 Dodge Journey?

Thermostats for the 2013 Dodge Journey start at $13.99 on AutoZone.com.

How many thermostats does a car have?

Because the primary and secondary thermostats are located on different areas of the engine, they have different temperature profiles when it comes to their opening temperatures.

We recommend reading:  Question: How Far Was Sheba's Journey To Solomon's Temple?

How much does a thermostat cost for a 2012 Dodge Journey?

2012 Dodge Journey Thermostat | AutoZone.com | $13.99

Does Dodge Journey have 2 thermostats?

Does the Dodge Journey have two thermostats? The primary thermostat for the 2.0L diesel and 2.4L gas engines is located in the thermostat housing/coolant inlet on the front of the water plenum. The 2.4L engine has a secondary thermostat, which is located in the cylinder head under the water plenum.

Where is water pump on Dodge Journey?

The water pump is an engine accessory that is bolted to the engine above the crankshaft pulley and is driven by a belt or chain.

What is the normal temperature for a Dodge Journey?

The normal operating engine temperature for most cars is between 195 and 220 degrees Fahrenheit, though most dashboard temperature gauges don’t display an exact temperature, instead showing cold and hot markings on the gauge’s edges and a normal range in the middle.

How do you start a car after it overheats?

When Your Engine Overheats, What Should You Do?

  1. Turn off the air conditioner and crank up the heat to relieve stress on the engine.
  2. Find a safe place to pull over. Pull over and shut off the car.
  3. Check and add coolant (if necessary).
  4. Restart the engine.

Where is the thermostat on a 2009 Dodge Journey?

The thermostat in the 2009 Dodge Journey 3.5 is located inside the coolant line that connects the water pump to the radiator, and its purpose is to allow the car to reach the optimum operating temperature in the shortest time possible.

We recommend reading:  Question: How Long Did The Israelites Journey In The Sinai Desert?

Where is the secondary thermostat located?

The primary thermostat is located on the front of the water plenum in the thermostat housing, and the secondary thermostat is located in the cylinder head under the water plenum; one or both thermostats could be bad.

Where is the thermostat located on a 2013 Dodge Avenger?

The thermostat in a 2013 Dodge Avenger with a 3.6-liter engine can be found under the hood on the passenger side of the engine bay, to the left of the engine, below the oil reservoir.

Leave a Reply

Your email address will not be published. Required fields are marked *