Readers ask: How To Change Oil On 2014 Dodge Journey 4 Cylinder?

Oil & Filter Change Dodge Journey (2009-2019) 2011 Dodge Journey Mainstreet 3.6L V6 FlexFuel

In most Dodges, you can wrap an old belt around the oil filter and unscrew it by hand; however, if your Journey is too low to the ground, use jack stands and safe jacking procedures.

How much oil does a 4 cylinder Dodge Journey take?

A 4-cylinder engine, for example, will need at least 5 quarts of oil, while a 6-cylinder engine will need around 6 quarts.

How much oil does a 2014 Dodge journey take?

4.5 quarts engine oil (with filter)Check the oil level after refilling.

Where is the oil filter in a Dodge Journey?

The oil filter is located under the vehicle, towards the front, and right in front of the oil pan on the 2015 Dodge Journey. The oil filter helps to remove contaminants from the engine’s oil that build up over time.

How do you remove the oil filter on a Dodge Journey?

Attach the 24mm socket and 1/2″ drive ratcheting wrench to the hex head on the top of the oil filter cap, and loosen it in a counter clockwise direction until it can be lifted out of the housing. Remove the old filter and discard it.

How much oil goes in a Dodge Journey?

Check the oil level after refilling. Capacity: 4.5 quarts (with filter)

How much oil does a Dodge Journey need?

If you have a 2.4L 4Cylinder engine, you’ll need 4. 5 US quarts of 5W-20 Fully Synthetic oil, while the 3.6L V6 can hold up to 5.9 US quarts. Dodge recommends changing your oil and filter every 7,500 to 10,000 miles.

We recommend reading:  How To Travel With Cologne?

Does Dodge Journey require synthetic oil?

What is the recommended oil change interval for a Dodge Journey? Synthetic oil should be changed every 7,500 to 10,000 miles, according to Dodge.

How often does a Dodge Journey need an oil change?

Dodge suggests getting your Dodge Journey’s oil changed.

What kind of oil does a 2014 Dodge?

When it comes time to change the oil in your 2014 Dodge Journey, Dodge recommends using SAE 5W-20 motor oil. Synthetic oil is designed to provide the best lubrication and protection possible, and will outperform standard conventional petroleum-based oils in Your engine.

Where is the oil filter in a 2014 Dodge Journey?

The oil filter for the 2014 Dodge Journey is located to the left of the engine, under the cover, and is secured by a black cap, next to the oil filler cap.

What kind of oil does a Dodge journey take?

The recommended oil type for a 2018 Dodge Journey is SAE 5W-20 full synthetic, with a capacity of 4.5 quarts for the 2.4L 4-cylinder engine and 5.9 quarts for the 3.6L V6 engine.

How do you reset the oil change light on a Dodge Journey?

Dodge Journey 2009-2016: How to Reset Oil Life

  1. Turn the ignition to RUN (second position)
  2. Slowly press the accelerator pedal all the way down three times within 10 seconds.
  3. Turn ignition OFF.
  4. Turn ignition to RUN or start the engine to verify if the oil life has been reset.

How do you reset the oil change light?

Insert the key into the ignition and turn it to the “on” position without starting the truck. Slowly press the gas pedal to the floor three times in 10 seconds before turning the ignition off. If the light remains on the next time you start the truck, repeat the process.

Leave a Reply

Your email address will not be published. Required fields are marked *