Often asked: How To Reset Oil Change Light On 2010 Dodge Journey?

Oil Change Light Reset Dodge Journey 2009 2010 2011 2012 2013 2014 2015

If the Oil Change Light Reset Dodge Journey 2009 2010 2011 2012 2013 2014 2015 is not performed after each oil change, the system will be unable to track when your next oil change is due. To reset the oil life monitor, follow the steps below.

Oil Change Light Reset Dodge Journey 2009 2010 2011 2012 2013 2014 2015 Procedure

Turn the ignition to the “RUN” position after pressing and releasing the accelerator pedal three times in 10 seconds.

Oil Viscosity and Capacity

When the engine oil and filter are changed, the 2.4 liter engine can hold about 4.5 quarts (4.3 liters) of 5W-20 oil, while the 3.5 liter engine can hold 5.2 liters of 10W-30 oil.

Not Working?

If the Oil Change Light Reset Dodge Journey 2009 2010 2011 2012 2013 2014 2015 procedure does not work to reset your oil life monitor, make sure you are following each step exactly and in the order listed in the Oil Change Light Reset Dodge Journey 2009 2010 2011 2012 2013 2014 2015 procedure; if not, restart your oil lightreset procedure search HERE.

Oil Life Monitor Reset Procedure Frequently Asked Questions

This page has been updated to provide a better understanding of how to reset the Oil Life Monitor.

Notice

Due to the wide range of vehicle makes and models, this information is meant to be used as a guide only; please consult the vehicle manufacturer for the correct specifications and repair procedures for your vehicle. This is general information and should not be taken as specific to any vehicle.

We recommend reading:  How Many Miles Per Gallon Does A Journey Dodge Get?

How do you reset the oil change light on a Dodge Journey?

The Dodge Journey’s “Oil Change Due” light will illuminate to remind you that it’s time to change the oil. Dodge Journey: Reset “Oil Change Due” Light

  1. Set the ignition to “ON/RUN.”
  2. Slowly press the accelerator pedal all the way down three times in a 10-second interval.

How do you reset the oil change light on a 2011 Dodge Journey?

Dodge Journey 2009-2016: How to Reset Oil Life

  1. Turn the ignition to RUN (second position)
  2. Slowly press the accelerator pedal all the way down three times within 10 seconds.
  3. Turn ignition OFF.
  4. Turn ignition to RUN or start the engine to verify if the oil life has been reset.

Why is my engine light on in my Dodge Journey?

If your Dodge Journey’s check engine light illuminates, it means there’s a problem that needs to be addressed right away, and your Dodge should be transported in as soon as possible. This blinking light usually indicates a severe engine misfire, allowing unburned fuel to leak into the exhaust system.

How often should you change your oil in a Dodge Journey?

What is the recommended oil change interval for a Dodge Journey? Synthetic oil should be changed every 7,500 to 10,000 miles. An oil change is one of the most basic and contentious services for your car. Dodge recommends getting your Dodge Journey oil changed every 7,500 to 10,000 miles.

Where is the battery on a 2010 Dodge Journey?

The Dodge Journey’s battery is located behind the front bumper on the driver’s side, and it is not necessary to remove the bumper to change the battery.

We recommend reading:  Often asked: How Far Is A Day's Journey?

What kind of oil does a 2011 Dodge journey take?

For 2011-2012 3.6L 24V V6 applications, 6 liters 5W-30 Dodge Journey motor oil, oil filter, and hardware. Meets Chrysler MS-6395 motor oil quality standards.

Leave a Reply

Your email address will not be published. Required fields are marked *