Readers ask: How To Reset 16 Dodge Journey Oil Light?

Oil Change Light Reset Dodge Journey 2016 2017 – Reset Your Oil Change Light

If the Oil Change Light Reset Dodge Journey 2016 2017 is not performed after each oil change, the system will be unable to properly track when your next oil change is due. To reset the oil life monitor for the Dodge Journey, follow the steps below.

Oil Change Light Reset Dodge Journey 2016 2017 Procedure

Turn the ignition to the “RUN” position after pressing and releasing the accelerator pedal three times in 10 seconds.

Oil Viscosity and Capacity

When the engine oil and filter are changed, the 2.4 liter engine can hold about 4.5 quarts (4.3 liters) of 5W-20 oil, while the 3.5 liter engine can hold 5.2 liters of 10W-30 oil.

Not Working?

If the oil change light reset procedure isn’t working, make sure you’re following each step in the Oil Change Light Reset Dodge Journey 2016 2017 procedure exactly and in the order listed; if this isn’t the oil life monitor reset procedure for your vehicle, try searching for it HERE.

Oil Life Monitor Reset Procedure Frequently Asked Questions

This page has been updated to provide a better understanding of how to reset the Oil Life Monitor.

Notice

Due to the wide range of vehicle makes and models, this information is meant to be used as a guide only; please consult the vehicle manufacturer for the correct specifications and repair procedures for your vehicle. This is general information and should not be taken as specific to any vehicle.

We recommend reading:  Utube How Do I Start My Spiritual Journey?

How do I reset my oil change light on my Dodge Journey?

Dodge Journey 2009-2016: How to Reset Oil Life

  1. Turn the ignition to RUN (second position)
  2. Slowly press the accelerator pedal all the way down three times within 10 seconds.
  3. Turn ignition OFF.
  4. Turn ignition to RUN or start the engine to verify if the oil life has been reset.

How often should you change your oil in a Dodge Journey?

What is the recommended oil change interval for a Dodge Journey? Synthetic oil should be changed every 7,500 to 10,000 miles. An oil change is one of the most basic and contentious services for your car. Dodge recommends getting your Dodge Journey oil changed every 7,500 to 10,000 miles.

What does check engine light mean Dodge Journey?

If your Dodge Journey’s check engine light illuminates, it means there’s a problem that needs to be addressed right away, and your Dodge should be transported in as soon as possible. This blinking light usually indicates a severe engine misfire, allowing unburned fuel to leak into the exhaust system.

How do you reset the oil change light on a 2011 Dodge Journey?

Steps to follow:

  1. Turn the ignition to RUN (second position)
  2. press the accelerator pedal all the way down three times in 10 seconds
  3. turn ignition OFF.
  4. Turn the ignition to RUN or start the engine to see if the oil life has been reset.

Leave a Reply

Your email address will not be published. Required fields are marked *