Question: 2009 Dodge Journey Camshaft Position Sensor Code How To Fix?

Camshaft Position Sensor Problems of Dodge Journey

We were driving from home to a doctor’s appointment on November 11, 2015, when the vehicle stalled, the engine malfunction light came on, and the vehicle lost all power. The vehicle would not restart, and we had to be towed to the dealership. We were able to coast off the highway and avoid being hit.

Can you bypass a camshaft position sensor?

Can the crankshaft position sensor be bypassed? No, the car will crank but not start unless the DME sees this signal in conjunction with the cam sensor, which is required for start-up and fuel injection sequence.

Where is the camshaft sensor located on a 2009 Dodge Journey?

The camshaft position sensor on the 2009 Dodge Journey 3.5 is located below the valve cover at the head of the engine.

What makes camshaft sensor go bad?

Due to accidents or normal wear and tear, the camshaft position sensor can fail or become worn down over time. There are a few warning signs to look for before your camshaft position sensor completely fails and shuts down the engine, necessitating replacement.

Is it hard to replace a camshaft sensor?

The camshaft sensor can be removed and replaced from underneath your vehicle, but it can also be done from the top by removing the air filter housing.

How much does it cost to replace camshaft sensor?

What is the average cost of a Camshaft Position Sensor Replacement? In most cases, this is a low-cost repair; the sensor will cost between $50 and $100, depending on the manufacturer, while installation will cost between $40 and $200, depending on the location.

We recommend reading:  Quick Answer: The Heroine's Journey: How Campbell's Model Doesn't Fit?

How much does it cost to fix camshaft timing?

Camshaft Repair Cost u2013 How Much Will I Have To Pay? The average cost of replacing a camshaft position sensor is between $120 and $300, and the typical camshaft repair cost is between $120 and $300.

Where is Cam sensor located?

The camshaft position sensor is located behind the valve cover on the right side of the engine compartment.

Will a car run without a crankshaft sensor?

The crankshaft position sensor is the most important of all engine management sensors; without it, the engine will not run; camshaft position sensors are also used so the management system knows what stroke the crankshaft is in at any given time.

Will a car run with a bad camshaft sensor?

Poor drivability A failing camshaft position sensor begins to lose its ability to quickly transfer data, causing your vehicle to sputter, accelerate poorly, lack power, stall, or even shut off. Mismatched fuel delivery and ignition timing, even if off by a few milliseconds, will cause your vehicle to sputter, accelerate poorly, lack power, stall, or even shut off.

Can you clean camshaft sensors?

Spray a small amount of solvent on the sensor and wipe it dry with another rag. Replace the camshaft sensor and tighten the screws. Connect the negative battery cable and reconnect the three wires.

Where is the crank sensor located on a 2009 Dodge Journey?

On the back of the engine, the crank sensor is located under the air cleaner box.

Where is the crank sensor on a 2010 Dodge Journey?

The CKP is located near the transmission at the back of the engine.

Leave a Reply

Your email address will not be published. Required fields are marked *