Question: How To Change Battery In Journey Key Fob?

Key Fob 1

Remove the back cover of your Dodge keyless remote with the metal key. Slide out the old battery and replace it with the new battery. Snap the battery cover back in place. Get outside the car and press the Unlock/Lock buttons. If the battery installation was successful, the doors should lock/unlock.

Key Fob 2

This Dodge key requires a CR2032 battery, which we recommend replacing with a lithium battery like the Energizer 2032 3-Volt lithium battery. This Dodge remote may be referred to as a 5-button remote, but it may only have three buttons.


On the back of your Dodge remote, there is a release switch; press it down with a flat screwdriver to release the metal/emergency key; pry out the old battery from the keyfob with the metal key or the screwdriver.


Vehicles like the Dart, Avenger, Challenger, Charger, Durango, Grand Caravan, 2500, 3500, 4500, 5500, C/V Tradesman, 200, 300, and Town are owned by Dodge, Ram, and Ram Trucks owners.

What size battery is in a Dodge Journey key fob?

Most Chrysler, Dodge, Jeep, or RAM key fobs use CR2032 batteries, but some may require a lithium battery instead. Bring your old battery to the store with you to find a suitable replacement; most CR2032 batteries are under $5 depending on the type, brand, and size packaging you purchase.

What kind of battery does a 2017 Dodge Journey key fob take?

We recommend using a lithium battery, such as the Energizer 2032 3-Volt lithium battery, instead of the CR2032 battery in this Dodge key.

Do you have to reprogram key fob after battery replacement?

The key fob will need to be reprogrammed to the vehicle because when the battery in the key fob was replaced, the key was reset, which is why nothing works with the key fob. You will need to reprogram the key fob remote to the vehicle after replacing the battery in the key fob remote.

We recommend reading:  How To Travel Route 66 Today?

How do you start a 2017 Dodge Journey with a dead key fob?

Start The Engine With A Dead Key Fob In A Dodge Journey

  1. Use the key to UNLOCK the vehicle door.
  2. Place the key fob on the START button, PUSH in, and press the BRAKE to start the vehicle.

How much does a key fob battery cost?

Key Fob Battery Replacement First and foremost, key fobs use inexpensive batteries that cost less than $5.

What kind of battery is in a key fob?

The most common types are CR2025 and CR2032 3-Volt batteries, which you can identify by looking in your vehicle’s owner’s manual or by examining the old key fob battery after it has been removed. Whichever type you require, you can find it at your local AutoZone.

How much is a dodge key fob?

The dealer’s price is $199.99, but you can get it for $119.99.

How do you program a key fob for a 2015 Dodge Journey?

Reprogramming a Key Fob

  1. Insert the key into the ignition and turn it to the “RUN” position.
  2. Press and hold the “UNLOCK” button on your remote for four seconds while pressing and holding the “PANIC” button.
  3. Press and release both the “LOCK” and “UNLOCK” buttons.

How do I program my 2016 Dodge Ram key fob?

How to Program a Key Fob for a Dodge RAM

  1. Put your key in the ignition and turn it on while holding the “UNLOCK” button.
  2. Hold the “UNLOCK” and “PANIC” buttons at the same time and release them both.

Leave a Reply

Your email address will not be published. Required fields are marked *