Quick Answer: How To Disconnect Battery Cable 2012 Dodge Journey?

How to Disconnect Dodge Journey Battery

The battery is located behind the front bumper on the driver’s side of a Dodge Journey, and you will need to remove the front wheel on that side to separate the battery from the vehicle.

Procedure

Set the parking brakes and jack up the vehicle from the front, driver’s side. Remove the wheel. Locate the negative battery terminal on top of the battery, which is marked with a negative (-) symbol next to the battery post.

How do you remove a battery from a Dodge Journey?

Steps to take

  1. Set the parking brakes.
  2. Locate the negative battery terminal on top of the battery.
  3. Break loose the lug nuts for the front wheel on the driver’s side.
  4. Jack up the vehicle at the front, driver’s side.
  5. Remove the wheel.

Where is the battery located at on a 2012 Dodge Journey?

The Dodge Journey’s battery is located behind the front bumper on the driver’s side, and it is not necessary to remove the bumper to change the battery.

What size battery does a 2012 Dodge Journey use?

The manufacturer specifies a group size 86 battery with 525 cold cranking amps for the 2012 Dodge Journey. Replacement batteries range in price from $50 to $150, depending on the brand and quality, and have an average life of three to five years.

How much is an alternator for a 2012 Dodge Journey?

Alternator for 2012 Dodge Journey | AutoZone.com | $239.99

How do you remove a battery from a Dodge Charger?

Flip the carpet floor panel open by opening the trunk.

  1. Loosen this nut until you can slide the battery terminal off.
  2. Pull the plastic positive shield off. Then loosen this 10mm nut and remove the wires from the positive terminal.
We recommend reading:  How Far Will A Shotgun Slug Travel?

What does battery current sensor do?

The battery current sensor is an amp clamp that measures current flow into and out of the battery and converts the flow into a variable duty cycle signal, which the sensor then sends to the BCM to indicate current flow.

When jump starting a car make sure it’s in?

Jump starting a car is usually done with the help of another car, but it can also be done with the help of a jump battery. You’ll be using jumper cables to connect the two cars’ batteries, so make sure the cars are in the right distance for the jumper cables to reach each battery.

How much is a battery for a 2010 Dodge Journey?

Find the right size, price, and amps for your 2010 Dodge Journey battery at AutoZone.com, starting at $159.99.

How do you jumpstart a Dodge Stratus?

Locate the positive and negative jump post locations on the driver’s side of the engine compartment, with a red plastic cap and cover for the positive jump post and a black cap and cover for the negative jump post.

How do I start my Dodge Journey with key?

Your Dodge vehicle can still be started:

  1. Flip the key fob over, slide the switch on the top left, and pull out the silver key.
  2. Place the key back inside the key fob for safekeeping.
  3. Push the start button with the Dodge key fob while your foot is on the brake.

Leave a Reply

Your email address will not be published. Required fields are marked *